What Wood to Use for Kumiko: Why I Use Basswood

What Wood to Use for Kumiko: Why I Use Basswood

If you're about to start your first kumiko panel, one of the first things to sort out is what wood to make the strips from. For me, that's basswood. It's what I use for my kumiko strips, and it's the lattice in my own pieces, like the kumiko lamp and the small kumiko box.

Basswood is a light hardwood with a very subtle grain, so it doesn't distract from the kumiko pattern itself. In kumiko, the pattern is what you want people to see, and the wood should stay out of its way.

Why basswood

It has a compressible nature and a subtle pore structure. Your work stands out without pronounced grain pulling the eye somewhere else.

The catch is finding it. You probably won't find basswood at your standard home improvement store.

On the lamp, I left the basswood lattice unfinished.

Getting basswood into strips

Making strips takes some setup. You need a jointer, a planer and a table saw, and I finish mine at the drum sander to get them to size.

I switched from buying pre-surfaced stock to skip-planed basswood for my strip production. Same end product. My board yield calculator post goes through the milling sequence I use, including drum sanding to panel thickness, crosscutting to length, ripping strips on the table saw and a final drum sand on the face.

If you'd rather skip the milling, my basswood strip bundle gives you ready-to-use strips. No jointer or planer required.

No table saw? The asa-no-ha starter kit doesn't need one. It comes with pre-notched and cut pieces for the grid, a bundle of strips for the pattern, and a PDF for the asa-no-ha pattern.

The tools I use once I have strips

Once you have strips, you need consistent bevels on your pieces, and that's what a good set of guide blocks gives you. My kumiko guide blocks are solid maple and the standard size handles the common patterns. There's also a long version built for larger panels, for example the three plus feet long panel I made for my wife.

Large kumiko panel

Each block is set up for specific angles. There's a set for asanoha, bigger sets that cover more of the angles, and custom angles if your pattern needs something else. They come with standard screws, and brass knurled thumbscrews are an optional upgrade.

The blocks don't do the job alone. You'll also need a good sharp chisel, a dozuki pull saw and strips. Those aren't included.

For birdsmouth cuts there's my birdsmouth jig. It's two plates of 13-ply Baltic birch, and it comes with basswood alignment pieces: the pins and the long stop you butt your stock against.

If you'd rather build your own birdsmouth jig, any stable wood or plywood will do. I made mine from some scrap Baltic birch plywood. Do you need Baltic birch? Nope, but it is nicer. I grabbed a spare basswood kumiko strip for alignment. Here's how I made mine.

Quick questions

What wood should I use for kumiko?

I use basswood for my strips and my lattice. It's a light hardwood with a very subtle grain that doesn't distract from the pattern.

Can I mill my own basswood strips?

Yep. You'll need a jointer, a planer and a table saw, and I finish mine at the drum sander. I buy skip-planed basswood for my strips.

Are the guide blocks and jigs made of the same wood as the strips?

No. My guide blocks are maple. The birdsmouth jig is Baltic birch with basswood alignment pieces.

Do you put a finish on the lattice?

Not normally. I leave the lattice on my pieces unfinished.

Back to blog